 |
 |
 |
 |
 
 PLEASE HELP SUPPORT E90POST BY DOING YOUR TIRERACK SHOPPING FROM THIS BANNER, THANKS! |
 |
BMW Garage | BMW Meets | Register | Today's Posts | Search |
 |
|
BMW 3-Series (E90 E92) Forum
>
CTS-V staggered configuration for 06 325i?
|
 |
|
Wheels and Tires forum Sponsored by The Tire Rack
Please help to directly support e90post by doing your tirerack shopping from the above link. For every sale made through the link, e90post gets sponsor support to keep the site alive. Disclaimer |
 |
|
|
Thread Tools | Search this Thread |
| 03-18-2013, 06:38 PM | #1 |
|
Registered
0
Rep 4
Posts |
CTS-V staggered configuration for 06 325i?
I am looking to swap my rims and tires from a 09 caddilac cts-v to a stock 06 325i. If anybody knows, please share any required mods to have this set-up work:
New Config: Front - 255/40R-19, 9", 51mm; Rear - 285/35R-19, 9.5", 56mm. Using the new wheel calculator in this forum, there is less clearance and extra wheel protrusion: Front: 42mm LESS clearance on the strut side, and the outside edge of the wheel will EXTEND an extra 8mm Rear: 54mm LESS clearance on the strut side, and the outside edge of the wheel will EXTEND an extra 10mm Thank you for any advise. |
| 03-19-2013, 12:30 PM | #2 |
|
Moderator
372
Rep 4,742
Posts |
The center bore on the CTS V wheel is too small to fit over the BMW hub nose.
__________________
Gary. Tire and Wheel Forum Moderator. Tire Rack Sales Rep Gary@Tirerack.com
http://www.tirerack.com/a.jsp?a=AH8&url=index.jsp Please refer to 'Gary/E90 Post' as your previous contact when you order online to help support this forum. |
|
Appreciate
0
|
|
| Bookmarks |
|
|
