[jotremar]

I'm changing my pre-halogen by bi-xenon LCI.
I only have bridged brown of ballast with black of h8/AE (bridging the mass from inside). I don't have done anything for high-beam at this moment...

The problem is that in low-beam xenon are flickering. What could it be? keep in mind that I go to code NFRM...

[EJ_3]

Flickering is normally cause when you need a ballast or have a cheap HID kit. Try getting separate ballast for each side instead of bridging.

[jotremar]

Originally Posted by Manny_World

Flickering is normally cause when you need a ballast or have a cheap HID kit. Try getting separate ballast for each side instead of bridging.

Ballast and headlight is from BMW, D1S from Ebay

[EJ_3]

Originally Posted by jotremar

Ballast and headlight is from BMW, D1S from Ebay

Factory ballast and eBay bulb or factory head lights with eBay HID conversion kit?

[jotremar]

Originally Posted by Manny_World

Factory ballast and eBay bulb or factory head lights with eBay HID conversion kit?

- Headlight from LCI-OEM
- bulb from Ebay
- ballast from BMW (Mitsubishi)

[BOOSTLEE]

Originally Posted by jotremar

- Headlight from LCI-OEM
- bulb from Ebay
- ballast from BMW (Mitsubishi)

you need to code VO for xenon

http://www.e90post.com/forums/showthread.php?t=500068

[jotremar]

The problem was a bad ground.

Now I have other problem. I add 522 to my VO.
Now AUTO_LWR_ENABLE is aktiv but when I try to change it to nicht_aktiv, it don't change (coding is ok, but not change).

PWM_ANST_FL_BIXENON don't exists, I can't find it on TRC. With bixenon I only find PWM_FL_BEI_BIXENON wert_01

AE left sometimes is off, but right is ok. It's very strange...