[tjobeid]

So im tackling the project on doing the LED angle eyes upgrade on e92.I am still a little confused at few things if someone can clarify it for me please.

Q: after removing the old angle eyes rings what are some ways you guys used to install the new rings? any pictures would be appreciated and i may do it full DIY while doing this to help the next person.

Q: what temp are you guys backing this at and for how long?

[tturbolife]

1. I cut the bottom where the angel eyes attach/screw into the headlights for the large angel eye, and glued it on the new angel eye. This was a difficult process and took me a few tries to get right. The smaller one I glued right over the existing one. I tried this at first but didn't think it looked right, so I removed the bumper, headlight, and baked it back open and did the process I said above

2. I did it at 200F for about 8 minutes. Make sure to remove everything you can from the headlights... bulbs, ballast, etc.

Good luck, it is a very difficult (but rewarding) process.

[LocDawgg]

Glue It on top of the existing ring if your new rings are thin. Use a heat gun would help