|
|
|
|
|
|
BMW Garage | BMW Meets | Register | Search | Today's Posts | Mark Forums Read |
|
BMW 3-Series (E90 E92) Forum
>
Spark Plug DIY Disaster (Beware of the Schwaben Socket) and rough idle
|
|
01-04-2014, 11:32 PM | #68 |
Brigadier General
691
Rep 3,696
Posts |
Sorry for reviving an old thread, anyone find a fix for this issue. Its been a thorn in my side for over 1.5 years. I just logged 30k miles on the last set of plugs and my new ones r doing the same thing. autohaaus Bosch oem plugs for both my current plugs an previous set. The original plugs never caused any shakes even at 45k miles.
|
Appreciate
0
|
01-04-2014, 11:41 PM | #69 | |
Major
34
Rep 1,093
Posts |
Quote:
__________________
07 335XI (A008006) 6AT ~94K miles JB4 G5 ISO VSRF DP's
09 135I M (VK80379) 6MT. Race Project car. 1) Install Cobb/piggyback? and Motiv 600 Kit[HTA3076R w/ tial .82] 2) JRZ or Moton suspension. 3) Build high flow intake manifold with multi-port fuel and relocate OFH 4) Build full cage 5) Complete staged twin setup with HTA4205R [w/Tial 1.16] 6) Complete dry sump system |
|
Appreciate
0
|
01-13-2014, 02:39 PM | #70 |
Brigadier General
691
Rep 3,696
Posts |
Okay... I never checked the gap's since I didn't have that tool. I just assumed that since it's an OEM bosch and the exact part for my car... that it should have come gaped correctly? I'll have to talk with my mechanic and see if we can go back in and check the gap for each one.
|
Appreciate
0
|
01-13-2014, 03:01 PM | #71 | |
Major
34
Rep 1,093
Posts |
Quote:
__________________
07 335XI (A008006) 6AT ~94K miles JB4 G5 ISO VSRF DP's
09 135I M (VK80379) 6MT. Race Project car. 1) Install Cobb/piggyback? and Motiv 600 Kit[HTA3076R w/ tial .82] 2) JRZ or Moton suspension. 3) Build high flow intake manifold with multi-port fuel and relocate OFH 4) Build full cage 5) Complete staged twin setup with HTA4205R [w/Tial 1.16] 6) Complete dry sump system |
|
Appreciate
0
|
12-30-2014, 05:54 PM | #72 |
Second Lieutenant
37
Rep 232
Posts
Drives: 2013 E92 Melbourne M3
Join Date: Feb 2014
Location: Los Angeles, CA
|
Sorry, I have to bring this back.
I have the raised idle issue with my car immediately after replacing the spark plugs and 1 coil on cylinder 5. The work was done by the BMW dealer. I have tried an adaptation reset and that didnt work. I replaced a vanos solenoid that failed and that seemed to have fixed the issue for about 600 miles. My DME fried and I got a new DME installed. The "raised idling" / misfire at idle issue came back and now the car constantly idles at 750rpm again. I will be replacing my vacuum lines soon and getting a walnut blast but i highly doubt doing any of these things will solve the issue. Has anyone had success fixing this issue with a regap or some insane reset? |
Appreciate
0
|
Bookmarks |
Thread Tools | Search this Thread |
|
|